LIGHT 5403914 - Caterpillar

Illustration 122 g03691027
Place clamp (11) over the hose.
Insert tube assembly (12) into the hose. Orient the tube assembly as shown in Illustration 122. Do not tighten the clamp.
Table 92
Installed Parts    
Item    Qty    Part Number    Part Description    
13     1     6V-2381     Clip    
14     1     6V-2382     Clip    
15     2     8T-4896     Hard Washer    
16     2     8T-4195     Bolt    
17     1     381-9658     Bracket As    
Illustration 123 g03691040
Install bracket assembly (17) to the exhaust support bracket with bolt (16) and hard washer (15) .
Illustration 124 g03691161
Illustration 125 g03691172
Install clips (13) and (14) around the fumes disposal line.
Secure the clips to bracket assembly (17) using bolt (16) and hard washer (15). Orient the clips and bracket assembly as shown in Illustrations 124 and 125.
Table 93
Installed Parts    
Item    Qty    Part Number    Part Description    
18     1     1S-0396     Clip    
19     1     8T-4223     Hard Washer    
20     1     8T-8919     Bolt    
Illustration 126 g03691238
Install clip (18) around the fumes disposal line. Attach the clip to the torque converter housing with bolt (20) and hard washer (19) .
Tighten all of the remaining bolts for the clips and clamps.Inspect for Fuel and Coolant Leaks
Illustration 127 g03731345
Use the following procedure to test for leaks with the fuel and coolant components that were replaced. If a leak is found. repair the leak and related components immediately.
Inspect all the installed components are tighten and torqued properly. Clean the engine of any debris.
Refill the coolant back to operating capacity.
Turn the fuel supply to the "ON" position.
Prime the fuel system without starting the engine and check all of the fuel line connections for leaks.
If no leaks are identified, start and idle the machine for 5 minutes. Shutdown engine and check again for any possible fuel leaks.
If no leaks are identified, restart the engine. Operate the machine bringing the coolant to operating temperature for 5 to 10 minutes.
Shut off the engine and immediately check for fuel and coolant leaks.
If no fuel leaks were found, reinstall the side panels.