LIGHTING AR-ROADING 1772036 - Caterpillar

You must read and understand the warnings and instructions contained in the Safety section of this manual before performing any operation or maintenance procedures.Drum Gear Reducer
Check Level
1. Move the machine until the plug is either at the three o'clock or nine o'clock position. Remove the plug.
Rotate the drum with the plug in the 12:00 o'clock position down to the 3:00 or 9:00 o'clock position. This will insure there is no oil trapped in the plug cavity and give a false "FULL" reading.
2. Maintain gear lubricant to the bottom of the plug.3. Clean and install the plug.Axle Brake Housing
Check Level
Maintain the level to the check plug.Axle Gear Reducer
Check Level
Located under the rear of the machine in front of the differential. 1. Remove fill/check plug located on front side of the axle reducer case.2. Maintain gear lubricant to the bottom of fill/check plug.3. Clean and install plug.Axle Planetaries
Check Level
1. Move the machine until the fill/check plug is in either the three o'clock or the nine o'clock position.2. Remove fill/check plug.3. Maintain gear lubricant to the bottom of plug.4. Clean and install plug.5. Repeat procedure on other planetary.Axle Differential
Check Level
Located under the rear of the machine. 1. Remove fill/check plug located in center of the differential case.2. Maintain gear lubricant to the bottom of plug.3. Clean and install plug.Drum Support Assembly
Check Level
1. Remove plug located at approximately the eight o'clock position.2. Maintain gear lubricant to the bottom of level indicator plug.3. Clean and install plug.Vibratory Bearing Reservoir
Check Level
1. Move the machine until indicator boss (1) is at its lowest level. 2. Remove check plug (2) and maintain lubricant to the bottom of the opening. 3. If necessary, remove fill plug (3) and add lubricant until it is level with the bottom of the opening for check plug (2).4. Install the check and fill plugs.Vibratory Bearing Reservoir (CS-431C Asphalt Compactor)
Check Oil Level
1. Move the machine on level ground until the welded bar is at the bottom of the drum. 2. Observe sight gauge. Bearing lubricant should be visible in the center of the sight gauge.3. If the lubricant level is low, remove plug at the top of the drum and add drum lubricant until it is visible in the sight gauge.4. Replace the plug.