LINE-FUEL 2500849 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 3100907 SOFTWARE GP-ELEK (ASD00606 & ASD00611 Only)
1 3100996 SOFTWARE GP-ELEK (ARL00476 Only)
1 LABEL EMISSION LABEL (See the Action Required.)
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 45% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
1.Order a replacement emission label for the machine.
a. Go to http://tmiweb.cat.com to order the label.
b. Select the ?Engine/Parts Data? under the ?TMI Web? menu.
c. Select ?Serial Number? from the drop-down menu at the top of the page.
d. Type the serial number into the window that is labeled ?Reference Number? and then select "Serial Number" from the ?Reference Description? drop down menu.
e. Click ?Retrieve Data?.
f. Click on the ?Emissions Data? link that is located on the top menu.
g. Select the ?Need emission replacement label- Click here!? link at the bottom of the form.
h. A new page will open. Complete all of the information to request a new label. If necessary, create an account to request a replacement label.
i. The label should arrive in about two weeks.
2. Check the engine for the location of the emission label. There may be more than one label installed on the engine.
3. Use a heat gun to heat the entire label. Hold the heat gun 3-4 inches away from the label.
4. Lift one corner of the label to start removal.
5. The label should be able to be removed once the heat has been applied. The label will become difficult to remove as it cools.
6. After the label has been removed, check the area for any excess glue or dirt. Clean the area before applying the new label.
If there are other labels, repeat the process.
7. Flash the software that is listed in the Parts Needed Table or the latest released software in SIS on the Engine ECM
8. After flashing the software, perform an ON, OFF, ON key cycle on the machine.
9. Operate the machine before returning to service.
OWNER NOTIFICATION
Owners in the following countries will receive the attached Owner Notification:
US
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
EXAMPLE COPY OF OWNER NOTIFICATION
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR REPLACING SOFTWARE ON CERTAIN 160H AND 163H MOTOR GRADERS
MODELS INVOLVED - 160H and 163H Motor Graders
Dear Cat Product Owner:
New software needs to be installed on the products listed below. The existing engine software does not meet the emissions certification for the machine. You will not be charged for the service performed.
Contact your local Cat dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
If you are no longer the owner of this product(s), please contact your local Cat dealer so that our records can be updated. Please refer the dealer to their Service Letter dated 10Mar2017 when scheduling