LINER 1351494 - Caterpillar

Emergency Stop
The Cold Planer is equipped with three Emergency Stop buttons at multiple locations on the machine. The purpose of the Emergency Stop, is to provide a means for an operator to stop the machine and shut down the engine if a dangerous situation occurs.Filter Monitoring
The hydraulic filter is equipped with a bypass switch to determine if the filter is plugged and bypassing oil around the filter.Fuse Status Monitoring
When one of the monitored fuses are blown or removed, a diagnostic becomes active on the display, indicating that the corresponding fuse has faulted. When the fuse is replaced, the fault is cleared.Temperature Sensors
The display will show the hydraulic oil temperature in either °C or °F. Warnings will occur when the temperature exceeds certain thresholds for a specified period.Ignition Key and Starting
The cold planer is equipped with a 4 position ignition key switch.The key switch has the following states:
OFF
ON
Engine Crank
Delayed Engine Shutdown OverrideThe ON position will turn on all ECMs and electronic components. The main power relay will be energized. The engine crank position will engage the engine starter and will incorporate the corporate strategy for the controls, warnings, and diagnostics. The delayed engine shutdown override will cancel the delayed engine shutdown feature and immediately shut down the engine.Horns
The Cold Planer is equipped with horn buttons at multiple locations on the machine. Each of the two control panels is equipped with a horn button. The horn button on the top control panel, activates loud front facing horns for communicating with the truck driver. The horn buttons on the lower control panel activates quieter horns located in the top operator station and are for communicating with the top operator only.Machine Idle Status
The machine idle status communicates whether the machine is actively working or at rest.
"Not Idle" - the machine is actively working
"Idle" - the machine is not considered to be doing workMachine System Standby Control
During milling operations, the Cold Planer typically fills a truck with the material being milled. When the truck becomes full, the cold planer must be stopped to allow time for the full truck to be exchanged with an empty one. This feature simplifies that process by bringing the machine to a stop and shutting down milling functions with the press of a single button. Pressing the same button again resumes all the milling functions.Oil Level Monitoring
When the hydraulic oil level is low, an event will be active and logged. The level status of the switch will be available in ET.Product Identification
The Product ID is a number that is used to let the ECM software know what type of machine the Product ID is installed on. The Machine Control ECM will be the only ECM that is able to program the Product ID. The Machine ECM will send out the Product ID information when requested. The Transmission ECM will read the Product ID from the J1939 data link and request the Product ID from the Machine ECM until Transmission ECM receives a response when the keyswitch turns on.Tow