LINER-CYLINDER BLOCK 5169693 - Caterpillar

Illustration 26 g02300513
Double-click the "Configure the Command/Status Parameter Data Identification" setpoint to change this value from the drop-down menu. Click the "OK" button to program.
Illustration 27 g02300515Configuring Outputs for System Events
System events are used to know when specific conditions are reached and to alert the control system of warning or shutdown conditions. To configure an output as a system event, go through the following menu options:
Double-click the "Output #N Usage Type" to change this value to "System Event" from the drop-down menu. Click the "OK" button to program.
Illustration 28 g02300673
The "Output #N Suspect Parameter Number (SPN)" and "Event Trigger Condition" parameters will now be visible in the right pane of the dialog.
Illustration 29 g02140898
Double-click the "Output #N Suspect Parameter Number (SPN)" set point to change this value from the drop-down menu. Click the "OK" button to program.
Table 3
Output System Events
Pressures Others Custom Events Temperatures Levels
Engine Oil Pressure Any SPN Digital Input #1 Custom Engine Coolant Temp Engine Coolant Level
Gas Pressure Accessory Data Link (EMCP 4.4 only) Digital Input #2 Custom Engine Oil Temp Engine Oil Level
Battery Charge System Voltage Digital Input #3 Custom Exhaust Temperature Fuel Level
Battery Voltage Digital Input #4 Custom Generator Rear Bearing Temperature External Tank Fuel Level
Emergency Stop Switch Digital Input #5 Custom Generator Winding #1 Temperature Bund Fluid Level
Engine in Cool down Digital Input #6 Custom
Engine Fail to Start Analog Input #1 Custom
Engine Speed Analog Input #2 Custom
Control Not in Auto Analog Input #3 Custom
Generator Current Digital Input Custom Event
Generator Frequency Analog Input Custom Event
Generator Real Power
Generator Voltage
Primary Data Link
SCADA Data Link (EMCP 4.4 only)
Service Interval Expired
Unexpected Engine Shut Down
Earth Fault
Earth Leakage
Engine Control
Fuel Leak
Air Damper Closed
Battery Charger Fail
Generator Breaker Open
Generator Breaker Closed
Any SPN
Accessory Data Link
Battery Voltage
Emergency Stop Switch
Engine In Cooldown
Engine Fail to Start
Engine Speed
Control Not in Auto
Generator Current
Generator Frequency
Generator Real Power
Illustration 30 g02140905
Double-click the "Output #N Event Trigger Condition" set point to change this value from the drop-down menu. Click the "OK" button to program.
Illustration 31 g02300717Configuring Outputs for SCADA Datalink
When an output is configured for SCADA data link, an active state will be sent over MODBUS. No alarms or warnings will be generated by the EMCP. To configure an output for SCADA datalink, follow the Steps below:
Double-click the "Output #N Usage Type" to change this value to "Data Link" from the drop-down menu. Click the "OK" button to program.
Illustration 32 g02271173Disabling Outputs
To disable an output, follow the steps below:
Double-click the "Relay Output #N Usage Type" to change this value to "Disabled" from the drop-down menu. Click the "OK" button to program.
Illustration 33 g02271174