LINER 7I0717 - Caterpillar

Illustration 27 g02993276
install spring (11) and spool (12) under plug (10) .
Illustration 28 g03002660
Install plug (10) Torque plug (10) to 79 8 N m (58 6 lb ft).
Illustration 29 g03002678
Install spool (7) , pusher (8) , and spring (9) into motor cover.
Illustration 30 g03002681
Install cover (6) Torque cover to 176 18 N m (130 13 lb ft).
Illustration 31 g03002683
Install O-ring seal (5) and backup ring (4) .
Illustration 32 g03002687
Position body casing as shown and install motor cover (1) . Install bolts (2) . Torque bolts (2) to 129 13 N m (95 10 lb ft). Install relief valves (3) . Torque relief valves (3) to 142 14N m (105 10 lb ft).
Use the following procedure to check for correct parking brake torque
Position final drive assembly as shown and secure to holding fixture.
Illustration 33 g03015764
Insert tooling (D) into splines of shaft (71) . Using tooling (E) , attempt to apply 104 N m (77 lb ft) to tooling (D) . If 104 N m (77 lb ft) is achieved, the parking brake torque is adequate. If 104 N m (77 lb ft) cannot be achieved, check the final drive motor components for damage.
Illustration 34 g02997287
Install plates (63) , bushings (62) , bearings (61) , and planetary gears (60) .
Illustration 35 g02997283
Install sun gear (57) . Install thrust plate (59) . Apply tooling (A) to threads and install bolts (58) . Torque bolts (58) to 35 2 N m (26 1 lb ft).
Illustration 36 g02996776
Install the three inner wheels (56) onto the carrier.
Illustration 37 g02996746
Install carrier (55) .
Illustration 38 g02996743
Install bearings (54) , planetary gears (53) , and sun gear (52) .
Illustration 39 g02996738
Install thrust plate (51) . Apply tooling (A) to threads and install bolts (50) . Torque bolts to 35 2 N m (26 1 lb ft)
Illustration 40 g03002419
Apply tooling (B) to the mounting flange of the gear casing (49) and Install cover (48) onto gear casing (49) . Install washers (47) and bolts (46) . Torque bolts to 14 1 N m (121 9 lb in)End By: Install final drive and travel motor