LINES G MAST 0357994 - Caterpillar

1. Remove the two bolts that hold cover (3) to the tube assembly.2. Remove clip (2) and disconnect wires (4).3. Loosen the two setscrews and remove magnet assembly (1) from the pin. 4. Remove two bolts, block (6) and switch assembly (5) from the cover.Install Bucket Positioner Control
1. Put block (3) and switch assembly (1) in position in cover (2). Install the bolts that hold them in place. 2. Install magnet assembly (4) in the pin and tighten the two setscrews.3. Connect wires (5) and install clip (6).4. Put the cover in position and install the bolts that hold it in place.5. Make an adjustment to the bucket positioner. See TESTING AND ADJUSTING.