LINES GP-FRONT 1049724 - Caterpillar

Illustration 1 g00636501
Install wiper motor (21) in position. Secure wiper motor (21) to wiper motor assembly (17) with three bolts (22) .
Illustration 2 g00636494
Install arm (20) on the shaft of window wiper motor (21). Tighten bolt (19). Bolt (19) will secure arm (20) to the shaft of window wiper motor (21) .
Illustration 3 g00636351
Install wiper motor assembly (17) in position inside the cab of the machine. Secure wiper motor assembly (17) with two bolts (18) .
Illustration 4 g00636484
Connect electrical connector (16) .
Illustration 5 g00636319
Install cover (13) in position.
Secure cover (13) with two screws (15) on the side of cover (13) .
Illustration 6 g00636312
Secure cover (13) with screw (14) on the side of cover (13) .
Illustration 7 g00636310
Secure cover (13) with four screws (12) on the front of cover (13) .
Illustration 8 g00636300
Install filter (11) in position. Secure filter (11) with two screws (10)
Illustration 9 g00636295
Install nut (9) on shaft (7) .
Illustration 10 g00636285
Install cover (8) on shaft (7) .
Illustration 11 g00636932
Be sure to push wiper arm head straight onto the wiper motor shaft. If wiper arm head is not installed straight the splines will not be formed properly when the nut is torqued.
Install wiper arm (3) on shaft (7). Position wiper arm (3) at 0° to 2 ° from the vertical centerline.
Install nut (5) and the washer on shaft (7). Hand tighten nut (5) on shaft (7) .
Torque nut (5 ) to 24 1 N m (17 0.7 lb ft).
Wait at least one hour. Torque nut (5) again to 24 1 N m (17 0.7 lb ft). Do not wait more than 4 hours.
Lower cover (4) on wiper arm (3) .
Illustration 12 g00488225
Install hose (6) on wiper arm (3) .Note: Do not use petroleum lubricants on the hose ends. Do not stretch the hose between connections.
Connect the hose of the window washer to the fitting. Install the hose to Dimension (A). Dimension (A) is 1.0 1.0 mm (0.04 0.04 inch).
Illustration 13 g01319086
Install grill (2). Secure grill (2) with six bolts (1) .
Connect the battery terminals. Move the battery disconnect switch to the ON position.
Start the machine.
Start the window wiper. Check the wiper arm for proper operation.