LINES GP-SIDESHIFT LOCK 1066251 - Caterpillar

Illustration 2 g01109155
By default, the "Method: 2 Points" method is selected and the Point 1 position fields are shown. Refer to Illustration 2.
Perform one of the following actions:
Press the "Here" soft key in order to use the current position of the guidance point that has focus.One of the "Blade: Left" or "Blade: Right" Soft Keys appears in the Sloping Surface Design dialog. This ensures that you know which blade tip the position is taken from.Note: If the "Here" soft key is not available, a high accuracy position is not available. For more information, see "Common Problems and Guidelines" in the Troubleshooting Section.
Use the arrow keys in order to enter the design northing, easting, and elevation values for the Start point. Press the "Next" key in order to move to the next field.
Press "Point 2".
Perform one of the following actions:
Move to the second point and press the "Here" soft key in order to use the current position of the guidance point that has focus.
Use the arrow keys to enter the design northing, easting, and elevation values for the second point. (Press the "Next" key in order to move to the next field.)When the two points are entered, the AccuGrade GPS system calculates the direction and grade values. To view the calculated values, press "Method: Pt / Dir".
Illustration 3 g01109157
Press the "Cross Slope" Soft Key. The "New Design: Sloping Surface" dialog shows the left and right cross slope fields. Refer to Illustration 3.
Perform one of the following actions:
Use the arrow keys to enter the left cross slope value.
Press the "Level" Soft Key.
Press the "Next" key in order to move to the "Right" field.
Specify the right cross slope as described in Step 8.
Illustration 4 g01109158
Press the "OK" key. The "Design Name" dialog appears. Refer to Illustration 4.
The AccuGrade GPS system provides a default name. Use the arrow keys to change the default design name.
Press the "OK" key in order to accept the name and return to the "Select Design File" dialog. The new design file is highlighted.
Press the "OK" key in order to load the new sloping surface design.Point-and-Direction Method
Instead of entering a second point, you can enter the direction and grade. The specified values are used to create the master alignment of the sloping surface.The direction specifies the bearing of the master alignment.The grade is the grade at which the master alignment rises or falls along the specified bearing. You can enter the grade as a ratio or a percentage.As you travel in the specified direction, a positive (+) grade rises and a negative (-) grade falls.The grade in a Grade field is normally expressed as a ratio. A grade of 1:1000 (or 0.1 percent) is nearly level and a grade of 1:8 (or 12.5 percent) is very steep for a road.Note: For any site, there is a grade that it is too steep for machines to operate at. Find out what this is for your workplace and make sure that you do not create roads steeper than this.To enter a sloping surface