LINES GP-AUXILIARY HYDRAULIC 1211894 - Caterpillar

Programming The Five Tools
In order to program any of the parameters of the machine, first enter "Service Mode" on the monitor. This procedure is described in full in Testing and Adjusting, "Service Mode - Enter" for the Tool Control System. After entering the password for the service mode, the following screen will be displayed on the monitor:
Illustration 1 g01000769
Illustration 2 g01008955
Monitor Panel (7) Up key (8) Left key (9) Right key (10) Down key (11) Cancel key (12) Set key (13) Menu key (14) OK keyUse down key (10) in order to highlight line 2. Use right key (9) and scroll until "CONFIGURATION" is displayed on the monitor. If the right key (9) is pressed again, "TOOL PROGRAM" will be displayed on the monitor.
Illustration 3 g01009235
Illustration 4 g00779463
After you reach the "TOOL PROGRAM" screen, press down key (10) in order to highlight the third line. The left side of the line ("TOOL#1") is initially highlighted. This is shown in illustration 4. Press left key (8) or right key (9) in order to scroll through the five tools that are available. After you reach the desired tool, press menu key (13) in order to highlight the right side of the line. This is shown in illustration 5.
Illustration 5 g00779470
In illustration 5, "TOOL#1" is the tool that is being programmed. The value for parameter 001 is on the fourth line. Press down key (10) in order to change the fourth line. If you want to move to the next parameter, press right key (9) when "001" is highlighted. The portion of the line that is highlighted will change to "002". The value for the new parameter will be displayed on the fourth line.Setting The Name of the Tool
It is possible to set up names for each of the five tools. Parameter 001 is the descriptive name of the tool. These names consist of 14 letters of your choosing. The following characters are valid in a name: (space), !, #, *, +, -, ., /, 0-9, :, ;, =, ? and A-Z.After you reach "Parameter 001", press down key (10) in order to highlight the fourth line. Use the keys for direction in order to change the value. Press set key (12) in order to save the new value. Line 3 will be highlighted after the value is saved.All of the other parameters are programmed in the same manner.