LINES GP-WATER 1393212 - Caterpillar

Illustration 15 g06168797
Select "Main Menu" (19) on the machine display.
Select "Machine Setup" (20).
Illustration 16 g06168801
Select "Vibe Turn On Speed" (21).
Illustration 17 g06168803
Select "Manual" mode (22).
Launch the Plus+1TM program on the computer to enable the vibe test mode.Note: First-time users need to perform the tasks in the Communication and Connections Wizard. This wizard allows the Windows® operating system to recognize the USB device. Follow the on-screen instructions.
Illustration 18 g06149932
Click "Status" icon (23).
Check the "Active Codes". Clear any open "Active Codes".
Click "Machine Control" (24).
Illustration 19 g06149954
Click "Hydraulics" (25).
Click "Vibe Test Modes" (26).
Illustration 20 g06149978
Click "Enable" icon (27) to enable the "Normal Vibe Test Mode".
Click "Enable" icon (28) to enable the "Fast Ramp Vibe Test Mode".
When "Fast Ramp Vibe Test Mode" is in "Enabled" mode, the Plus+1 TM program is launched.
Illustration 21 g06168817
Press vibratory control switch (29) on the propel lever. The vibratory control switch must be held in the ON position for at least 2 seconds for the vibratory system to actuate.
Watch pressure on Tool (A) in port "Ma" (14). An initial pressure reading will register on the gauge for a brief period, and then the pressure reduces to operating pressure. Record the initial pressure reading as the main relief pressure. The main relief pressure should be 38000 2000 kPa (5500 290 psi).Note: The force that is needed to overcome the inertia of the weights causes the pressure in the vibration system to momentarily reach the relief valve setting. This force should be the initial pressure reading.
Use vibratory control switch (29) to stop the vibratory system.
Use vibratory frequency switch (17) to place the drums in the high frequency/low amplitude mode.Note: Two things indicate when the vibratory system is in the high frequency/low amplitude mode. First, "Vibe Frequency Mode High" will appear on the display. Second, two of the LEDs next to vibratory frequency switch (17) will be illuminated.
Press vibratory control switch (29) on the propel lever. The vibratory control switch must be held in the ON position for at least 2 seconds for the vibratory system to actuate.
Watch the pressure on Tool (A) in port "Mb" (15). An initial pressure reading will register on the gauge for a brief period, and then the pressure reduces to operating pressure. Record the initial pressure reading as the main relief pressure. The main relief pressure should be 38000 2000 kPa (5500 290 psi).Note: The force that is needed to overcome the inertia of the weights causes the pressure in the vibration system to momentarily reach the relief valve setting. This force should be the initial pressure reading.
Use vibratory control switch (29) to stop the vibratory system.
Place the engine in ECO mode or in low idle.
Move parking brake switch (2) to the ON position.
Move engine start switch (8) to the OFF position.
If the pressure at port "Ma" (14) and the pressure at port "Mb" (15) are within the specified range. Go to Step 43. If the pressure at port "Ma" (14) and/or the pressure at port "Mb" (15) are outside the specified range, adjust the appropriate valve