LINES GP-PROTECTION 1480169 - Caterpillar

Keep away from the area behind the sprocket when the track is pulled on to the sprocket with tooling (B).
1. Put the machine in position on the track with the sprocket near the end of the track. Install tooling (B) on the track and sprocket as shown. Drive the machine forward and pull the track on to the sprocket with tooling (B) until the track is forward of a vertical center line through the sprocket. 2. Remove tooling (B) and install tool (C) on the track as shown. Fasten a hoist. Move the machine and track forward. Use the hoist and tool (C) as a guide for the track over the carrier roller and idler. 3. Remove tool (C) and install tool (A) under the grouser of the track shoe under split master link (2). Drive the machine forward to tighten the track against tool (A). Make a connection of split master link (2).4. Put 2P2506 Anti-Seize Compound on the threads and install bolts (1). Tighten the bolts to a torque of 90 20 N m (65 15 lb. ft.), then tighten the bolts an additional 120°.5. Install the master shoe. Put 2P2506 Anti-Seize Compound on the threads of the bolts that hold the master shoe in place. Install the bolts and tighten to a torque of 90 20 N m (65 15 lb. ft.), then tighten the bolts an additional 180°.6. Make an adjustment to the track. See TRACK ADJUSTMENT.7. Install the cover over the hydraulic track adjuster.