LINES GP-EXTENDABLE STICK 1622351 - Caterpillar

Illustration 30 g03749790
(4) 350-7075 Piston Motor Gp (61) 148-8390 Elbow Gp (62) 387-4625 Hose As (63) 148-8327 Connector As (64) 387-4599 Tube As (65) 148-8347 Elbow As (66) 417-3349 Hose As
Attach 148-8390 Elbow Gp (61) to top port on 350-7075 Piston Motor Gp (4) .
Connect 387-4625 Hose As (62) into 148-8390 Elbow Gp (61).
Install 148-8327 Connector As (63) into port (H) on 350-7075 Piston Motor Gp (4) .
Connect 387-4599 Tube As (64) into 148-8327 Connector As (63) and route tube (64) towards right-hand side of machine.
Attach 148-8347 Elbow As (65) into port (J) on 350-7075 Piston Motor Gp (4) .
Connect 417-3349 Hose As (66) onto 148-8347 Elbow As (65) and route hose (66) up and towards the left of the machine. Refer to Illustration 30 for orientation of hoses and tube assembly.
Illustration 31 g03750700
(K) Fan Bypass valve (66) 417-3349 Hose As (67) 148-8360 Elbow As
Connect 148-8360 Elbow As (67) to the open port on fan bypass valve (K) made by removing the existing hose and adapter earlier.
Connect 148-8360 Elbow As (67) to the free end of. 417-3349 Hose As (66) .
Illustration 32 g03751019
(L) Existing hardware (M) Tee Port (62) 387-4625 Hose As
Route 387-4625 Hose As (62) up and to the right side of the machine. Push 387-4625 Hose As (62) through the existing grommet in the compartment shield and attach hose (62) onto the tee port where the existing hose was removed at (M). Secure 387-4625 Hose As (62) using existing hardware at (L) .
Illustration 33 g03751161
(N) Hose assembly (P) Hardware (64) 387-4599 Tube As
Free end of 387-4599 Tube As (64) attaches to hose assembly (N) and secure using preexisting hardware and bracket (P) .
Illustration 34 g03801684
Location for film on hood
Apply the appropriate film. Use 225-4130 Film (US) or 225-4131 Film (INTL) in the area designated on the cooling system.
Table 2
Film Locations    
Machine     Dimension A     Dimension B    
966M and 972M    
180 20 mm (7 0.8 inch)    
640 20 mm (25.2 0.8 inch)    
Illustration 35 g03728756
Install relay assembly (68) in position 6.Configuring Software
Software Configuration and Calibration of the 387-1355 Fan Control Ar (Variable Pitch Fan). This feature can be configured and must be activated with Product Software Programming System (PSPS) or a service tool. Use a Caterpillar Electronic Technician (Cat ET) and select the proper Electronic Control Module (ECM).
Select "SERVICE " from the menu.
Select "CONFIGURATION" from the menu.
Double click on the desired feature on the configuration screen.
Select the desired status of the feature and click "OK".
The feature will be activated on the next power cycle.