LINES GP-FUEL 2152581 - Caterpillar

Illustration 9 g01451483
(16) 192-7054 Sleeve
Insert sleeve (16) into the opening in the rear liner. See Illustration 9.Secure the sleeve in place by bending the locking tabs against the back of the rear liner.
Illustration 10 g01416700
Insert the radio into sleeve (16). Push the radio into the liner until the radio snaps in position. See Illustration 10.
Illustration 11 g01453081
(5) 200-5728 Radio Harness As
Install harness assembly (5) to the connector on the back of the radio. See Illustration 11.
Illustration 12 g01451541
(5) 200-5728 Radio Harness As (11) 258-4067 Cover
Slide cover (11) onto the radio.Note: As you slide the cover onto the sleeve, pull harness assembly (5) through the opening in the rear of cover (11). See Illustration 12.
Illustration 13 g01451515
(2) 179-4324 Locknut (3) 8T-0328 Hard Washer (5) 200-5728 Radio Harness As (6) 9U-8746 Coaxial Cable Assembly (11) 258-4067 Cover (12) 5C-7261 Nut (13) 5P-4116 Hard Washer (14) 258-4074 Bracket
Install bracket (14) to the stud that extends through cover (11) with locknut (2) and hard washer (3). Then, secure bracket (14) to the weld stud with nut (12) and hard washer (13). Tighten nut (12) to a torque of 15 3 N m (11 2 lb ft). See Illustration 13.
Install coaxial cable (6) to the connector on the back of the radio. See Illustration 13.
Illustration 14 g01451565
(5) 200-5728 Radio Harness As (6) 9U-8746 Coaxial Cable Assembly (7A) Insert from the 258-4039 Spacer (7C) Insert from the 258-4039 Spacer
Install insert (7A) in order to seal the opening around the harness assembly (5). Install insert (7C) in order to seal the opening around the coaxial cable (6). See Illustration 14.Note: Install the inserts by removing the protective paper strip from the adhesive and by pressing the spacer to the flange.
Illustration 15 g01451568
(20) Screw (21) Connector assembly (22) Washer (23) Screw
Install antenna (4) to the mounting bracket on the left wall of the canopy.
Remove screw (23) and remove the antenna from the base assembly.
Unscrew screw (20) in order to remove connector assembly (21) .
Position the antenna's base with washer (22) on the front side of the mounting bracket and position connector assembly (21) on the rear side of the mounting bracket. Then, reinstall screw (20) into connector assembly (21) in order to secure the antenna's base to the mounting bracket.
Reinstall the antenna to the base with screw (23) .
Connect coaxial cable (6) to connector assembly (21) .
Connect harness assembly (5) to harness connector C-C10 on the 258-4102 Cab Harness As . This 8-pin connector is located on the left side of the Electronic Control Monitor (ECM).
Table 3
Harness Connector C-C10    
Position    Wire Number    Color    
1     509-C70     White    
2     508-C68     Purple    
3     200-C75     Black    
4     -     -    
5     122-C74     Red    
6     191-C76     White    
7     512-C72     Green    
8     511-C71     Brown    
Reconnect