LINES GP-SYNCHRONIZING 2245054 - Caterpillar

Illustration 15 g01103967
(24) Steering Charge Filter
(25) Filter Bypass Switch
(26) Charge Pressure Sensor Filter bypass switch (25) is located in the filter housing for steering charge filter (24), as shown. When the filter element is full of debris and the bypass valve opens, filter bypass switch (25) will open. The operator will be notified with a warning message from Advisor. If this occurs and the oil is at normal operating temperature, inspect the filter element for restrictions.Charge pressure sensor (26) monitors the charge oil pressure before the charge oil flows through the charge filter. Charge pressure sensor is located on steering charge filter (24), as shown.Power Train ECM
Illustration 16 g01103968
(27) Power Train ECM Power train ECM (27) is located behind a panel at the rear of the operator station. The power train ECM receives electrical signals. Then, the ECM sends electrical signals in order to control the response of the steering hydraulic system.Rotary Position Sensors on the Steering Control Lever
Illustration 17 g01103974
(20) Steering Control Lever
(29) Rotary Position Sensors Three rotary position sensors (29) sense the movement of steering control lever (20) when the steering control lever is moved to STEER LEFT or STEER RIGHT. The sensors inform the power train ECM of the position of the steering control lever. Position sensors (29) are located at the base of the housing of the steering control lever.Solenoids on the Steering Pump
Illustration 18 g01103977
(30) Steering Pump
(31) Pump Control Solenoid (Right Steer)
(32) Pump Control Solenoid (Left Steer) Pump control solenoid (31) and pump control solenoid (32) are located on steering pump (30). The pump control solenoids control the actuator piston in steering pump (30).Location of Components for the Fan Electrical System
Reversing Switch (If Equipped)
Illustration 19 g01104110
(33) Reversing Switch Reversing switch (33) is located on the right console in front of the blade control lever. The reversing switch allows the operator to reverse the direction of the fan manually.Pressure Sensor for the Fan Drive Pump
Illustration 20 g01104111
(34) Fan Drive Pump Pressure Sensor
(35) Fan Drive Pump Fan drive pump pressure sensor (34) measures the pressure at the outlet of the fan pump. This is the oil that is delivered to the inlet side of the fan motor. This pressure sensor sends a signal to the engine ECM. The engine ECM uses this signal to control pump output.Fan drive pump pressure sensor (34) is located on fan drive pump (35), as shown.Solenoid for Reversing Valve (If Equipped)
Illustration 21 g01104112
(36) Fan Reversing Valve
(37) Reversing Valve Solenoid Reversing valve solenoid (37) on reversing valve (36) is located inside the front radiator guard.Reversing valve solenoid (37) directs pilot oil to the reversing valve spools in order to change the direction of