LINES GP-BOOM 2291827 - Caterpillar

Introduction
This Special Instruction covers the installation procedure for 259-4889 Chassis Wiring Gp on the models and applications listed above.Do not perform any of the procedures until you have read the information in this publication. Safety Section
Illustration 1 g00104545
Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. Also, before you repair the equipment, attach a "Do Not Operate" warning tag. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.Required Parts
Table 1
Parts List for 259-4889 Chassis Wiring Gp - 01    
Item    Qty    Part No.    Description    
1     8     3S-2093     Cable Strap    
2     1     6G-2263     Spacer    
3     10     7K-1181     Cable Strap    
4     1     116-0118     Clip    
5     1     259-4890     Chassis Harness As    
6     2     8T-4121     Hard Washer    
7     1     8T-4133     Nut    
8     1     8T-6466     Bolt    
Illustration 2 g03631721
Illustration 3 g03631979
Installation Procedure
Illustration 4 g03630216
Close up of Area E (E) 2-pin connector with 780-PU and 200-BK (2) 6G-2263 Spacer (4) 116-0118 Clip (5) 259-4890 Chassis Harness As (6) 8T-4121 Hard Washer (7) 8T-4133 Nut (8) 8T-6466 Bolt
Attach the wiring harness (5) to valve group (9) .
Secure harness (5) using one clip (4), spacer (2), bolt (8), washer (6) and nut (7) .
Illustration 5 g03631618
Routing of electrical harness (F) Ground connection 200-BK (G) Connection to chassis harness 780-PU (1) 3S-2093 Cable Strap (3) 7K-1181 Cable Strap (5) 259-4890 Chassis Harness As
Illustration 6 g03631862
Routing of electrical harness (G) Connection to chassis harness 780-PU (3) 7K-1181 Cable Strap
Route the wire harness through the engine compartment. Attach the ground strap to the frame at location (F). Torque bolt to 30+-7 Nm (22+-5 lb ft).
Secure harness (5) to the rest of the machine harness using straps (1) and (3) as needed.