LINES GP-CHASSIS 2389610 - Caterpillar

Illustration 1 g01100109
(A) Display panel
(B) Display (Stereo)
(C) Display (Music)
(1) Power switch
(2) AM/FM band selector
(3) Preset buttons
(4) "Tone" control
(5) Button for scan and auto memory function
(6) "Tune" button
(7) "Tune" button
(8) Volume control
(9) Volume control Note: When the machine is in operation turn down the volume of the radio.Note: The radio can be used only when the battery disconnect switch and the engine start switch are in the ON position.Note: When a button is pushed a beep will occur. (1) Power Switch - Push the power switch in order to turn on the radio. Push the power switch again in order to turn off the radio. (2) AM/FM Band Selector - After you push the AM/FM band selector, the selected radio band appears on display panel (A). (3) Preset Buttons - The circuitry in the memory system allows you to preset six radio stations. To preset any of the "preset" buttons, follow the "Presetting Radio Stations" procedure. (4) Tone Control - Music is optimized by pressing the tone control so that display (C) will show "MUSIC". (6) and (7) "Tune" Buttons - Push the "tune" buttons in order to select a radio station. Pressing "tune" button (7) will decrease the frequency. Pressing "tune" button (6) will increase the frequency. Pressing the "tune" button for less than 0.5 seconds changes the radio station one at a time. Pressing the "tune" buttons for more than 0.5 seconds will change the frequency automatically until a radio station is found. (8) and (9) Volume Control - Push the volume control in order to control the volume. Push the upper volume control in order to increase the sound level and push the lower volume control in order to decrease the sound level.Presetting Radio Stations
Illustration 2 g01100116
(E) Display
(3) Preset buttons
(6) "Tune" button
(7) "Tune" button
Turn on the radio. Select the AM band or the FM band.
Select the first radio station by using tuning switch (6) or tuning switch (7).
Depress one of preset buttons (3) for more than 1.5 seconds. The radio station is stored on display (E).
Push preset button (3) in order to tune in the radio station.
Repeat the same procedure for the remaining preset switches. Note: When the preset station is faint use the "tune" buttons to locate a stronger signal.Scan and Auto memory
Illustration 3 g01100127
(D) Display (Frequency)
(F) Display (Scan)
(3) Preset buttons
(5) Button for scan and auto memory function Scan - Press button (5) for less than 0.5 seconds in order to listen for 5 seconds to each of the preset radio stations. Press button (5) again in order to stop scanning through the preset stations and keep listening to the current station. When this function is used "SCAN" is shown on the display. The frequency of the radio station is also shown on the display.Auto Memory - Press button (5) for more than 1.5 seconds in order to automatically store the radio stations that have the strongest signal. The radio stations are stored in the six presets (3). Stations that are already stored in the radio's memory will