LINES GP- 2402089 - Caterpillar

Illustration 5 g01318815
Press "OK". Raise the blade to near the maximum height. Measure the distance from the left blade tip to the same point on the ground. Enter this measurement in the Blade Elevation dialog that is represented in Illustration 5.
Press "OK".Proceed to Step 9.
Raise the blade to the maximum height. Press "OK".You are prompted to move the blade to the bottom of the blade's range of lift. The "Current pitch" reading decreases.
Press "OK".This information is used in order to calculate the angle that the blade has moved through a full range of lift with respect to the blade pivot point.
Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
A message appears warning you that the valve calibration will cause the blade to start moving. Press "OK" in order to continue the calibration. Press the "ESC" key in order to cancel the calibration.A message appears telling you to make sure the Auto/Manual remote switch is set to "Auto".
Illustration 6 g01318915
Press "OK". The lift valve calibration will start.Note: