LINES GP-RIDE CONTROL 2469802 - Caterpillar

1. Remove two bolts (1), and remove guard (2). 2. Disconnect wire harness (3). Remove three bolts (4). Remove speed sensor (5) and spacer (6).3. Replace any grommets (7) that are worn or damaged. 4. Remove spacer (8), and remove shaft (9).5. To install the speed sensor, install shaft (9) and spacer (8). Position spacer (6) and speed sensor (5). Install three bolts (4).6. Connect wire harness (3). Position guard (2), and install bolts (1) that hold it.Disassemble And Assemble Electronic Speed Sensor
Start By:a. remove electronic speed sensor 1. Remove four bolts and washers (4). Remove rotor (3) and retainer (2) from housing (1).2. Remove ring (9) from rotor (3). Remove bearing (5) from the rotor with tooling (A).3. Remove grommet (6), spacer (7), and spacer (8). Check the condition of the grommet. If it is worn or damaged, make a replacement of the grommet with a new part. The following steps are for the assembly of the electronic speed sensor.4. Install spacer (8), spacer (7), and grommet (6) in housing (1).5. Put retainer (2) in position on rotor (3). Put the rotor and retainer in a press, and press bearing (5) into position against the shoulder of the rotor hub with tool (B).6. Install rotor (3) and retainer (2) in housing (1) with four bolts and washers (4).End By:a. install electronic speed sensor