LINES GP-POWER TRAIN OIL 2500896 - Caterpillar

Installation Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00552113
Install swivel (24) with washers and four bolts (23). Tighten bolts to a torque of 22.5 2 N m (17 1.5 lb ft).
Illustration 2 g00552111
Install bracket assembly (22) with washers and two bolts (21). Tighten the bolts.
Illustration 3 g00552107
Connect lines (20), (19), (18), and (17) to the swivel.
Illustration 4 g00552058
Connect lines (16), (15), (14), and (13) to the swivel.
Illustration 5 g00552056
Connect lines (12) and (11) to the swivel.
Illustration 6 g00552053
Connect lines (10), (9), and (8) to the swivel.
Illustration 7 g00552014
Connect lines (7), (6), (5), (4), and (3) to the swivel.
Illustration 8 g00552009
Connect the two speed switch's electrical harness to the bottom of plate assembly (2) with washers and eight bolts (1) .End By: Install the cab heater. Refer to Disassembly and Assembly, "Cab Heater - Remove and Install".