LINES GP-FUEL FILTER 2532529 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 3S-6224 Electric Hydraulic Pump (115 Volt)(1) 1
6V-3175 Double Acting Cylinder 1
4C-9634 Puller Stud 1
9U-6832 Nut 1
4K-0684 Hard Washer
5P-8625 Receiving Sleeve 1
9U-5337 Bearing Puller Adapter 1
B 3S-6224 Electric Hydraulic Pump (115 Volt)(1) 1
6V-3175 Double Acting Cylinder 1
4C-9634 Puller Stud 1
9U-6832 Nut 1
4K-0684 Hard Washer 1
5P-8625 Receiving Sleeve 1
9U-5336 Bearing Puller Adapter 1
(1) 8S-8033 Electric Hydraulic Pump (230 Volt) is available.Start By:
Remove the bucket control linkage. Refer to Disassembly and Assembly, "Bucket Linkage - Remove". Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00698265
Remove lip seals (1) from power link (2).
Illustration 2 g01331640
Use Tooling (A) to remove sleeve bearing (3) from the open end of the power link.
Use Tooling (A) to remove the sleeve bearing from the opposite side of the power link.
Remove the sleeve bearings from the closed end of the power link.
Illustration 3 g00698407
Remove lip seals (4) from the bore for the idler link in the stick.
Illustration 4 g00698417
Attach an suitable lifting device to Tooling (B), as shown.
Use Tooling (B) to remove the sleeve bearing from the stick.
Use Tooling (B) to remove the sleeve bearing from the opposite side of the stick.