LINES GP-WINCH 2692087 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5P-6215 Jack Stand 2 Start By:
Separate the track. Refer to Disassembly and Assembly, "Track - Separate".
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hose assemblies for installation purposes. Plug all hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Illustration 1 g00538695Note: Adjust the height of Tooling (A) so that there is enough clearance between the sprocket and track links for removal of the final drive and motor.
Raise the side of the machine and install Tooling (A) under the frame.
Illustration 2 g00538723
Rotate the final drive until drain plug (1) is at the bottom. Drain the oil into a suitable container for storage or disposal. The capacity of the final drive assembly is 1.7 L (0.5 US gal).
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Illustration 3 g00538793
Remove four bolts (2) and cover (3) from the rear of the undercarriage frame.
Illustration 4 g00597225
Disconnect hose assemblies (4).
Illustration 5 g00597227
Attach a suitable lifting device to final drive and travel motor assembly (6). Remove 12 bolts (5). Remove the final drive and travel motor assembly. The combined weight of the final drive and the travel motor is approximately 118 kg (260 lb).