LINES GP-DRAFT FRAME 2731810 - Caterpillar

Illustration 1 g01931573
Approximate dimensions are shown. Dimensions will vary depending on the configuration and the options. (A) 3.58 m (11 ft 9 inch) (B) 3.71 m (12 ft 2 inch) (C) 13.17 m (43 ft 3 inch)
Table 1
623G Wheel Tractor-Scraper    
Engine     C15 Acert Diesel Engine
LHX1-Up    
Transmission     Eight speeds (forward)
One speed (reverse)
, M1R1-Up    Intended Use
This Wheel Tractor-Scraper is an earthmoving machine as described in ISO 6165:2001 and is classified as a scraper. This machine is used to cut, load, transport and discharge material through a forward motion.Application/Configuration Restrictions
The operator station is ROPS certified to a tractor only mass of 17500 kg (38590 lb) as tractor portion of tractor-scrapers per Table 1 of ISO 3471:1994. This excludes scraper weight and this weight excludes payload.For the maximum approved operating weight refer to the loaded weight in Operation and Maintenance Manual, "Rated Load".Maximum side grade operation without machine articulation is 51% grade.Note: The listed restriction assumes a machine operating perpendicular to a side grade, graded ground surface, nominal payload, homogeneous payload distribution in the bowl and operating on a dry, firm underfooting. Refer to the Operation and Maintenance Manual, "Slope Operation" for more information.Maximum side grade operation with machine articulation is 22% grade.Note: The listed restriction assumes a machine operating at a very slow ground speed on a graded ground surface, nominal payload, homogeneous payload distribution in the bowl and operating on a dry, firm underfooting. Refer to the Operation and Maintenance Manual, "Slope Operation" for more information.Service brake holding capability on a grade is 25% grade.Note: The listed restriction assumes the brake components are within working specifications, a graded ground surface and a dry, firm underfooting. Evaluate the condition of the machine and the environment and use appropriate judgment to maintain control of the machine.Parking brake holding capability on a grade is 15% grade.Note: The listed restriction assumes the brake components are within working specifications, a graded ground surface and a dry, firm underfooting. Evaluate the condition of the machine and the environment and use appropriate judgment to maintain control of the machine.While descending on a grade do not exceed 2600 RPM or damage to the engine may occur.Use only in nonexplosive gas environments.