LINES GP-BOOM 2794817 - Caterpillar

Illustration 13 g00495924
Note: Check the condition of hub (20). Refer to Guideline For Reusable Parts, SEBF8087.
Remove retaining rings (19) from each side of stator (18) .
Heat the stator to a temperature of 121°C (250°F). Maintain the temperature for one hour. Remove splined hub (20) from stator (18) .
Illustration 14 g00796414
Use Tooling (C) in order to remove retaining ring (21). Remove spacer (22). Remove torque converter impeller (24) and carrier assembly (28) .
Illustration 15 g00796419
Use Tooling (C) in order to remove the retaining ring from the carrier assembly. Use a press in order to remove output shaft (29) from carrier assembly (28) .Note: Use steps 19 and 20 for the removal of a split bearing assembly (newer models).
Illustration 16 g00796423
Remove piston ring (38) from output shaft (29) .
Remove bearing (39) and the plate. Use a press to remove the race from output shaft (29) .Note: Use step 21 for the removal of a single bearing assembly (older models).
Illustration 17 g00840860
Use Tooling (C) in order to remove the retaining ring from output shaft (29) .
Illustration 18 g00796044
Remove seal ring (23) from carrier assembly (28) .
If necessary, remove the locating dowel at the base of the shaft on carrier assembly (28) .
Illustration 19 g00796424
Note: To prevent possible damage, do not remove splined adapter (41) from stator (18) unless it is necessary.
Remove retaining ring (40) from both sides of stator (18).
Illustration 20 g00496086
Remove bolts (25) and gear (26) from impeller (24) .
Illustration 21 g00496508
Remove bearing (27) from impeller (24) .
Illustration 22 g00496510
Remove retaining ring (30) and cap (31) from housing (32) .
Illustration 23 g00496512
Use Tooling (C) in order to remove retaining ring (33) from the turbine.
Illustration 24 g00496515
Remove turbine (34) from housing (32) .
Illustration 25 g00496541
Remove bolts (36) and hub (35) from turbine (34) .
Illustration 26 g00496545
Remove bearing (37) from housing (32) .