LINES GP-PILOT 3236658 - Caterpillar

This machine has been certified to the standards that are listed on the certification film. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification film.Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information.Engine Coolant (9)This safety message is positioned on the underside of the radiator cap access cover on top of the engine compartment.
Illustration 12 g01371640
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.
Refer to Operation and Maintenance Manual, "Cooling System Coolant Level - Check" for more information.Accumulator (10)This safety message is on the blade cushion accumulator which is on the left-hand side of the front frame.
Illustration 13 g01325881
High Pressure Cylinder.Rapid discharging from disconnecting or disassembly can result in personal injury or death. See your Caterpillar dealer for tools and instructions for relieving pressure or charging. Precharge only with dry nitrogen gas.
Refer to Operation and Maintenance Manual, "Blade Cushion Accumulator - Check" for more information.Accumulator (11)This safety message is positioned on the brake accumulators. The brake accumulators are at the rear of the cab.
Illustration 14 g01371642
Hydraulic accumulator contains gas and oil under high pressure. Improper removal or repair procedures could cause severe injury. To remove or repair, instructions in the service manual must be followed. Special equipment is required for testing and charging.
Refer to Operation and Maintenance Manual, "Brake Accumulator - Check" for more information.No Clearance (12)This safety message is positioned on the left side of the machine on the engine enclosure.
Illustration 15 g01371647
Connect the steering frame lock between the front and the rear frames before lifting, transporting, or servicing the machine in the articulation area. Disconnect the steering frame lock and secure the steering frame lock before resuming operation. Severe injury or death could occur.
Hydraulic System Oil (13)This safety message is positioned near the hydraulic tank filler cap and this safety message is located near the hydraulic tank sight gauge.
Illustration 16 g01637005
If the incorrect hydraulic oil viscosity is installed and the machine is operated in cold temperatures, the machine hydraulic system may not respond at normal speeds. Sluggish machine control could result in injury or death. Use the correct oil viscosity for operating the machine in cold weather, and warm-up the machine before operating the machine in cold weather. See Operation and Maintenance Manual, "Engine and Machine Warm-Up" for more information on operation in cold temperatures. See Operation and Maintenance Manual, "Lubricant Viscosities" for the recommended oil viscosity. If the hydraulic oil needs to be changed, see Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the procedure to change the hydraulic system oil.
Recoil Spring (14)This safety message is positioned at the bottom of the parking brake housing.
Illustration 17 g01379131
This housing contains a highly compressed spring