LINES GP-SWING 3261803 - Caterpillar

Make sure that the RCI purifier is correctly assembled on fuel tank assembly (A), not assembled on return line (B).
Illustration 41 g03830870
Install water fuel sensor (38) on the primary fuel filter. Secure the harness for water fuel sensor (38) with clip (19) and cable strap (54).
Illustration 42 g03830934
Illustration 43 g06008385
Illustration 44 g06008396
Connect harness assembly (43) to the engine harness assembly using the following:
(19) Clip
(36) Two cable straps
(43) Harness assembly
(45) Clip
(46) Clip
(54) Ten cable strapsRefer to Illustration 45 and Illustration 46.
Illustration 45 g06008408
Illustration 46 g06008427
Leave extra length in harness assembly (43) to flex with engine movement
Strap harness assembly (43) with the existing harness from the wiring group chassis along the vertical plate that holds the fan guard. Refer to Illustration 45. Leave extra length in harness assembly (43) to flex with engine movement. Refer to Illustration 46.
Illustration 47 g03831034
Strap existing harness from wiring group chassis by strapping the harness on clip (28) bolted on the new primary filter bracket using bolt (62) and a washer (61).
Illustration 48 g03831051
Illustration 49 g03831213
The mounting surface for relay assembly (12) must extend to or beyond the end of relay assembly (12).
Illustration 50 g03831218
Install relay assembly (12) using bolt (63) and washer (74). Connect harness assembly (43) to relays As (12) as shown in Illustration 48, Illustration 49, and Illustration 50.
Illustration 51 g03831221
Connect the harness from the chassis wiring group to the charge filter as shown in Illustration 50.
Illustration 52 g03831227
Declare the water in fuel sensor as installed using the Electronic Technician Software. Go to Service menu, then Configuration. Under the C6.6 engine section , click on Optional Sensor Parameters (E), and install (F).
Illustration 53 g03831237
When the primary/water separator filter needs to be serviced, light (G) will pop up on the dash.
Illustration 54 g03841378
Water in fuel system indicator (L3) will illuminate when water need to be drained from the fuel system water separator.