LINES GP-HYDROSTATIC 3338302 - Caterpillar

Illustration 1 g03688411
Required Tools
Table 1
Required Tools    
Quantity     Part Number     Part Name    
1     419-5974     Adapter    
1     448-0532     Harness As    Note: An Ethernet cable that is long enough to flash the display is also required.Cable Assembly
Connect the Ethernet cable to the 419-5974 Adapter .
Connect the Ethernet cable to the computer Ethernet port.
Connect the 419-5974 Adapter to the 448-0532 Harness As .
Turn the keyswitch to the OFF position.
Remove the display from the housing so the rear of the display panel can be accessed.
Connect the 448-0532 Harness As to the 6-pin connector on the back of the display.Note: There are two 6-pin ports on the back of the display, each port is keyed differently. The 448-0532 Harness As will only connect to the correct port on the display.Flashing
Note: A Communications Adapter III does not need to be connected in order to flash the display.
After connecting the cables to the display as instructed above, open Cat® ET. Do not connect to an ECM, the communications method must be set up for the Ethernet connection.
Illustration 2 g03676551
Select "Utilities", then "Preferences", then "Modify" from the Cat® ET menu.
After the preferences screen has opened, Select the "Communications" tab.
Illustration 3 g03687661
Select "Ethernet Direct Connection".
Illustration 4 g03687668
Select "Intel(R) XXXXXLM Gigabit Network Connection" from the drop-down menu and select "OK".
Turn the keyswitch to the "ON" position.
Connect to Winflash.
Illustration 5 g03687676
Cat® ET will now connect using the Ethernet connection to the display.
Illustration 6 g03687784
In Winflash, select the folder tab, and browse to find the updated flash file.
Illustration 7 g03687786
Once the file has been selected, the system will prompt you to update the operating system on the display. Select "Yes".
Illustration 8 g03687816
Select "Begin Flash" to update the display software.
Illustration 9 g03506153
Once the flash has completed, the "Flash Completed Successfully" dialog box will be displayed.
Select Exit from the dialog box.
Turn the keyswitch to the OFF position. The display has been successfully flashed. The hardware can now be disconnected from the display.
Reassemble the display panel.
Turn the keyswitch to the ON position. Verify the display and the keypad (if applicable) are working properly.