LINES GP-BACKHOE AUXILIARY 3492410 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-1114     Vacuum Cap     1    
B     6V-9511     Face Seal Plug     2    
C     6V-9832     Cap As     2    
At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00910597
Install Tooling (A) on the hydraulic tank. Attach hose (1A) to the nipple on Tooling (A) and to an air supply. Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull a vacuum on the hydraulic system.
Illustration 2 g00910328
Remove bolts (1). Remove grill assembly (2) .
Illustration 3 g00910501
Disconnect hose assemblies (3) .
Remove bolts (4) and swing bracket assembly (5) outward.
Illustration 4 g00910503
Remove nut (6) in order to remove fan spider assembly (7) .
Illustration 5 g00910505
Remove bolts (8). Remove gear motor (9) from bracket assembly (5) .