LINES GP-HYDRAULIC FILTER 3642389 - Caterpillar

A machine may shift if improper procedures or equipment are used for lifting and tying down for transport. Ensure that proper equipment and procedures are used for lifting and tying machines down for transport. If a machine shifts it could cause personal injury or death.
The weights and the instructions that are specified below relate to the machines that are manufactured by Caterpillar Inc.
The weight of the D400 Ejector Body Series II is 32840 kg (72380 lb).Use properly rated lifting equipment in order to lift the machine. If a lifting beam is used, the beam must be wide enough to prevent contact with the machine. Move the parking and secondary brake control to the ENGAGED position. Retract the ejector blade and stop the engine. Install the steering frame locks on the steering cylinders.Suitable lifting points are provided on the machine. Position the crane in order to lift the machine on a level plane.
Illustration 1 g00691423
Use the two lifting eyes that are positioned above the wheels of the truck (1).
Illustration 2 g00691634
Use the two holes (2) that are positioned at the rear of the ejector body for lifting. Do not use the lifting holes (3) at the front of the ejector body. These holes are used to lift the ejector body off the machine. Each machine is equipped with holes for tie-downs.
Illustration 3 g00643096
Two holes are positioned at the front of the machine.
Illustration 4 g00708926
Two holes are positioned at the center of the machine.
Illustration 5 g00643099
One hole is positioned at the rear of the machine.Attach the tie-downs at each location.Obey all of the laws that govern a load of those dimensions and a load of that weight.Consult your Caterpillar dealer for shipping instructions for your machine. Refer to Operation and Maintenance Manual, "Shipping the Machine".