LINES GP-RIPPER 3783288 - Caterpillar

5. Install O-ring seal (10) on body (8) and put the body in position on body (7).6. Install key (11) in drive gear assembly (5).7. Install two gears (12) and (13) on the gear assemblies. Make sure the groove in gear (13) is in alignment with key (11) in drive gear (5).8. Install two bearings (16) in cover assembly (15) with tooling (A) and press. The distance from the top of the bearing to the surface shown after assembly is 0.62 in (1.57 mm). CAUTION Make sure the joint in both bearings (16) is in the correct location. The location of the joint is an angle of 30° 15° from the center line of the two bearing bores in the direction of groove (14).9. Install the lip type seal in cover (15) with tooling (A) and press. The seal lip must be toward the outside of the cover. Install the seal until it makes contact with the shoulder in the cover. Put a thin layer of SAE 30 oil on the seal lip. 10. Install O-ring seal (16) on cover (15). Put the cover in position on body (8).11. Install four bolts (18) and washers than fasten cover (15) to manifold (1). Install O-ring seal (17) on the cover.12. Install two bolts (19) and washers that fasten manifold (1) to cover (15).13. Install O-ring seal (20) on elbow (21). Install the elbow on the pump assembly with four bolts and lockwashers.End by:a) install transmission and torque converter charging pump REMOVE TRANSMISSION AND TORQUE CONVERTER SCAVENGE PUMP
1. Drain the oil from the hydraulic tank.2. Drain the oil from the steering system hydraulic tank.3. Disconnect hose assemblies (1) and (2) from the scavenge pump.4. Disconnect hose assembly (3) from the steering pump.5. Remove bolts (4) that hold the scavenge pump to the torque converter cover. Use two 3/8" -16 NC forcing screws to loosen the scavenge pump from the torque converter cover. Use two persons to remove transmission and torque converter scavenge pump (5). The weight of the scavenge pump is 60 lb (27 kg). INSTALL TRANSMISSION AND TORQUE CONVERTER SCAVENGE PUMP
1. Clean the surfaces of the torque converter cover and scavenge pump that make contact with each other. Install a new gasket (2) on the torque converter cover.2. Use two persons to put transmission and torque converter scavenge pump (1) in position on the torque converter cover. Install the bolts that hold it.3. Connect hose assembly (3) to the steering pump.4. Connect hose assemblies (4) and (5) to the scavenge pump.5. Fill the steering system hydraulic tank with SAE 10 oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.6. Fill the hydraulic tank with SAE 10 oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE. DISASSEMBLE TRANSMISSION AND TORQUE CONVERTER SCAVENGE PUMP
Start by:a) remove transmission and torque converter scavenge pump1. Loosen nut (1) about four or five turns.2. Install tooling (A) on the nut and gear (2). Loosen the