LINES GP-STICK 3923277 - Caterpillar

Illustration 2 g00611187
If the bearing was removed from gear (8) , install the bearing in the gear. The bearing must be located at a distance of 2.50 0.50 mm (0.10 0.020 inch) below the surface of the side of the gear. This distance is measured on the gear with the smaller shoulder. The inside diameter of the gear should be 124.980 0.020 mm (4.9210 0.0008 inch) after installation.
Put gear (10) in position on gear (8) . Install bolts (6) .
Put the following components in position on shaft (5) : gear (8) and other gear (10) . Install bolts (9) . Do not tighten the bolts at this time.
Attach