LINES GP-FRONT 3967895 - Caterpillar

Install Tooling (D) into collet (16).
Tighten Tooling (D) to a torque of 500 N m (369 lb ft).
Tighten Tooling (D) to a torque of 800 N m (590 lb ft).
Continue to increase the torque of Tooling (D) in 100 N m (74 lb ft) increments in a circular pattern until collet (16) is removed.Note: The collets are not reusable. Discard the collets.
Use the following procedure to remove the six bolt pattern collet.
Illustration 10 g06333196
Remove plugs (14) and bolt (15).
Illustration 11 g06333371
Install Tooling (E) into collet (16).
Tighten Tooling (E) to a torque of 200 N m (148 lb ft).
Tighten Tooling (E) to a torque of 300 N m (221 lb ft).
Continue to increase the torque of Tooling (E) in 50 N m (37 lb ft) increments in a cross pattern until collet (16) is removed.Note: The collets are not reusable. Discard the collets.
Illustration 12 g06333523
Illustration 13 g02617178
Use Tooling (F) and a suitable lifting device to remove pin (17) far enough out to attach a suitable lifting device. The weight of Tooling (F) is approximately 34 kg (75 lb). Remove Tooling (F). Attach a suitable lifting device onto pin (17). The weight of pin (17) is approximately 52 kg (115 lb). Remove pin (17).
Repeat