LINES GP-HYDRAULIC 4379103 - Caterpillar

Illustration 2 g00325403
Use two persons to install seat (28). The weight of the seat is 36 kg (80 lb).
Illustration 3 g00325383
Raise handle (27) and slide seat (28) onto the tracks of seat suspension (29).
Install stop bolt (26) on the seat suspension. Note: Steps 7 through 11 are for installing the support for the implement control.
Illustration 4 g00325035
Illustration 5 g00325034
Engage the lower shaft support bearing with the lower shaft.
Rotate support (25) into position.
Slide upper shaft (23) through the upper shaft support bearings.
Tighten setscrews (24) at both ends of upper shaft (23).
Illustration 6 g00325033
Install cover (21) and screws (22) to support (25).
Illustration 7 g00325032
Install inner cover (19) and ten screws (20).
Install knob (18). Note: Steps 14 through 20 are for installing the support for the steering control.
Illustration 8 g00325031
Engage lower shaft support bearing (17) with the lower shaft.
Illustration 9 g00325030
Rotate support (16) upward toward the seat until upper shaft (15) will slide in the upper bearings.
Slide upper shaft (15) through the bearings of support (16).
Illustration 10 g00325029
Tighten setscrews (14) at both ends of upper shaft (15).
Illustration 11 g00325028
Install inner cover (13) and screws (12).
Install knob (11).
Illustration 12 g00325027
Install outer cover (9) and screws (10).
Install guard assembly (7) and handle (8).
Illustration 13 g00325026
Install storage compartment (3) and bolts (6).
Illustration 14 g00325025
Illustration 15 g00325024
Install panel (5) and mat (4).
Install bolts (2) at the rear portion of storage compartment (3).
Illustration 16 g00325023
Close lid (1) for the storage compartment.
Start the engine and check for leaks. Note: After the steering frame lock has been separated, check for proper operation of the steering controls and of the implement controls.End By:
Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".