LINES GP-WATER 4516338 - Caterpillar

Illustration 1 g01287164
(1) Exhaust manifold (2) Exhaust outlet (3) Turbocharger turbine wheel (4) Turbocharger compressor wheel (5) Air inlet (6) Air line (7) AftercoolerClean inlet air from the air cleaners is pulled through the air inlet (5) into the turbocharger compressor by the turbocharger compressor wheel (4). The rotation of the turbocharger compressor wheel then forces the air through a tube to aftercooler (7). The aftercooler lowers the temperature of the compressed air before the air flows into the inlet chambers in each cylinder head. This cooled and compressed air fills the inlet chambers in the cylinder heads. Air flow from the inlet chamber into the cylinder heads is controlled by the inlet valves.There are two inlet valves and two exhaust valves for each cylinder. Refer to Systems Operation, "Valve Mechanism". The inlet valves open when the piston moves down on the inlet stroke. The cooled, compressed air is pulled into the cylinder from the inlet chamber.The inlet valves close and the piston starts to move up on the compression stroke. When the piston is near the top of the compression stroke, fuel is injected into the cylinder. The fuel mixes with the air and combustion starts. The force of the combustion pushes the piston downward on the power stroke. When the piston moves upward again, the piston is on the exhaust stroke. The exhaust valves open and the exhaust gases are pushed through the exhaust port into exhaust manifold (1). After the piston makes the exhaust stroke, the exhaust valves close and the cycle starts again.Exhaust gases from exhaust manifold (1) go into the turbine side of the turbocharger. The exhaust gases cause turbine wheel (3) to turn. The turbine wheel is connected to the shaft that drives the turbocharger compressor wheel (4). The exhaust gases exit through the exhaust outlet (2).