LINES GP-VENT 4596511 - Caterpillar

Illustration 10 g00747632
Illustration 11 g00747631
Install spacer (22).
Use Tooling (D) to install retainer ring (21).
Illustration 12 g00747630
Illustration 13 g00747629
Install stator (20).
Use Tooling (D) to install retainer ring (19).
Illustration 14 g00747628
Install impeller assembly (18) on the housing.
Install bolts (17) and tighten to a torque of 60 7 N m (44.0 5.0 lb ft).
Illustration 15 g00747627
Install bearing (15) on shaft (14).
Install seal ring (16).
Illustration 16 g00747626
Illustration 17 g00747605
Install shaft assembly (14) in the rotating group.
Install retainer ring (13) with Tooling (A).
Illustration 18 g00747621
Install both bearings (11) and retaining rings (12) in housing (7).
Illustration 19 g00747816
Lower the temperature of both drive gear assemblies (40) and install the assemblies in housing (7).
Illustration 20 g00747614
Install retaining rings (9) and (10) on the drive gear shafts.
Illustration 21 g00747612
Illustration 22 g00747610
Install Tooling (C) and position housing (7) over torque converter assembly (8).
Install bolts (6).
Illustration 23 g00747609
Install sensor (5) in the carrier. Adjust sensor (5) in order to obtain a 0.89 mm (0.035 inch) air gap.
Illustration 24 g00747608
Install yoke (4), O-ring seal (3), retainer (2) and bolt (1). Tighten bolt (1) to 105 15 N m (75.0 11.0 lb ft). End By:
Install the torque converter outlet relief valve. Refer to Disassembly and Assembly, "Torque Converter Outlet Relief Valve - Install".
Install the torque converter. Refer to Disassembly and Assembly, "Torque Converter - Install".