LINES GP-BRAKE 4703762 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2 Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01027146
Fasten Tooling (A) and a suitable lifting device to flywheel housing (1).
Remove bolts (2) and bolt (3) that fastens the flywheel housing to the cylinder block.
Remove bolts (4). Remove flywheel housing (1). The weight of flywheel housing (1) is approximately 25 kg (55 lb). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 2
B 1U-8846 Gasket Sealant 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Apply Tooling (B) to the entire mounting face of the flywheel housing prior to installation.
Illustration 2 g01027146
Fasten Tooling (A) and a suitable lifting device to flywheel housing (1). The weight of flywheel housing (1) is approximately 25 kg (55 lb). Position flywheel housing (1) on the cylinder block. Install bolts (4).
Install bolts (2) and bolt (3). End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".