LINES GP-FRONT 4949491 - Caterpillar

TARGET="_parent">Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Fumes Disposal Filter Differential Pressure - Check
Generator Bearing Temperature - Test/Record
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Voltage and Frequency - Check
Walk-Around Inspection
Initial 250 Service Hours
Cylinder Pressure - Test/Record
Every 250 Service Hours
Battery Electrolyte Level - Check
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Fumes Disposal Filter - Drain
Every 1000 Service Hours
Aftercooler Condensation - Drain
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Crankcase Pressure - Measure
Crankshaft Vibration Damper - Inspect
Crankshaft Vibration Damper - Inspect
Engine Crankcase Breather - Clean
Engine Oil - Change
Engine Oil Filter - Change
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash and Bridge - Check
Flexible Coupling - Inspect
Gas Pressure Regulator Condensation - Drain
Generator Winding Insulation - Test
Hoses and Clamps - Inspect/Replace
Inlet Air System - Check
Radiator - Clean
Valve Stem Projection - Measure/Record
Water Pump - Inspect
Every 2000 Service Hours
Carburetor Air/Fuel Ratio - Check/Adjust
Compressor Bypass - Check
Generator Bearing - Lubricate
Generator - Inspect
Generator Set Vibration - Inspect
Stator Lead - Check
Every 3000 Service Hours
Spark Plugs - Inspect/Replace
Every 4000 Service Hours
Crankcase Blowby - Test/Record
Cylinder Pressure - Test/Record
Engine Mounts - Inspect
Engine Protective Devices - Check
Ignition System Timing - Check/Adjust
Starting Motor - Inspect
Every 8000 Service Hours
Fumes Disposal Filter Element - Replace
Rotating Rectifier - Check
Turbocharger - Inspect
Every 10 000 Service Hours
Generator Bearing - Inspect
Between 10 000 and 20 000 Service Hours
Engine Oil Temperature Regulator - Replace
Overhaul (Top End)
Between 22 000 and 40 000 Service Hours
Overhaul (In-Frame)
Every 24 000 Service Hours or 3 Years
Coolant (NGEC) - Change
Between 45 000 and 80 000 Service Hours
Overhaul (Major)