LINES GP-TILT & TIP CYLINDER 4T5817 - Caterpillar

Washing System Inspection
Inspect the system for proper operation at the beginning of each shift.Note: When you perform maintenance above ground level, use appropriate devices such as ladders or man lift machines. If equipped, utilize the machine anchorage points and use approved fall arrest harnesses and lanyards.
Improper operation of an access platform could result in injury or death. Operators must carry out their duties properly and follow all instructions and guidelines given for the machine and access platform.
Note: When you access the system for inspection, be sure to observe safe procedures for access. Maintain a three-point contact and/or use a body harness.
Ensure that the tank is full of washer solvent.
Inspect the nozzles and other washer system components for blockage.
Washer Spray Pattern
Washer Nozzle Pressure
Verify that there is no damage to the components of the system.
Frayed Hoses
Leaking Hoses
Loose ClampsNote: Replace any frayed/leaking hoses and tighten loose clamps.Manually clean any excessive debris build-up from around the washers and sensors. Adjust any washer nozzle that is not cleaning the sensors correctly. Check for washer fluid flow to the nozzles, clean, or replace affected nozzles. If all nozzles are working but flow is low, replace the filter between the tank and the pumps. If pressure to the system appears low, check to make sure that all pumps are providing pressure and fluid flow. Check each pump individually.