LINES GP-FUEL INJECTION 7C5160 - Caterpillar

Required Tools
Table 1
Required Tools Qty
4C-6500 Digital Thermometer 1
or
2F-7112 Thermometer 1
6B-5072 Reducing Bushing 1 Test Preparation
Personal injury can result from escaping fluid under pressure.If a pressure indication is shown on the indicator, push the release valve in order to relieve pressure before removing any hose from the radiator.
Making contact with a running engine can cause burns from hot parts and can cause injury from rotating parts.When working on an engine that is running, avoid contact with hot parts and rotating parts.
Illustration 1 g03780806
Test location for 3606 and 3608 engines
(1) Plug
(2) Temperature sensor
Illustration 2 g03780856
Test location for 3612 and 3616 engines
(1) Plug
(2) Temperature sensor
Turn off the engine.
Allow the engine to cool.
Remove plug (1).
Install the 4C-6500 Digital Thermometer or the 6B-5072 Reducer Bushing and the 2F-7112 Thermometer.
Connect Cat®Electronic Technician (ET) to the service tool connector. Test Procedure
Start Cat ET.
Start the engine. Run the engine until the temperature reaches the desired range according to the test thermometer.
Monitor the coolant temperature on Cat ET. Monitor the coolant temperature on the test thermometer.
Compare the coolant temperature on Cat ET to the coolant temperature on the test thermometer. If the two measurements are about equal, the sensor is okay. If the two measurements are not about equal, there may be a problem with the sensor. Install a new sensor and verify that the problem is resolved.
Install plug (1).