LINES GP-WATER 7C6134 - Caterpillar

This change was effective with the machines listed in Table 1. This change is adaptable to earlier machines by performing the rework procedure.
Rework Procedure
Illustration 1.
Left Side of Engine.112-6219 Bracket (8). Clip (9) for Engine Oil Dipstick. Clip (10) for transmission Fill Tube.1. Remove transmission fill tube and the engine oil dipstick from the 112-6219 Bracket (8). See Illustration 1.
Illustration 2. Bracket (8). Bracket (8). Washer (12).2. Remove the 112-6219 Bracket (8) from the engine. See Illustration 2.
Illustration 3.
The 112-6219 Bracket. Dimension A = 82 mm (3.228 in). Dimension B = 30 mm (1.181 in).Diameter C = 11.5 mm (.452 in).3. Drill an 11.5 mm (.452 in) diameter hole in the 112-6219 Bracket, 82 mm (3.228 in) (A) from the right edge and 30 mm (1.181 in) (B) below the top edge. See Illustration 3.4. Install the 112-6219 Bracket on the engine. See Illustration 2.
Illustration 4. Left Side of Bracket (8). 171-5284 Bracket (3) mounted in the machine.5. Install the 171-5284 Bracket (3) and the clip (9) for engine oil dipstick using 8T-4908 Bolt (6), Nut (2), and Washer (7). See Illustration 4.6. Install the clip (10) for the transmission oil fill tube. See Illustration 1.
Illustration 5. 7C-4354 Clip (4).171-5284 Bracket.8T-4136 Bolt (5).8T-4121 Washer (1). 7. Place the 7C-4354 Clip (4) around the hose. Attach the Clip (4) to the 171-5284 Bracket (3) using 8T-4136 Bolt (5) and 8T-4121 Washer (1).