LINES GP-WATER 7C8122 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 595 -
B - Multipurpose Grease -
C - Guide Stud
3/8 - 16 by 5 inch 4
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Clean the sealing surfaces of the engine oil pan and the cylinder block.
Illustration 1 g06088426
Apply Tooling (A) to oil pan gasket (5). Install the oil pan gasket on the engine oil pan. Install Tooling (C) in the engine oil pan.
Apply Tooling (B) to the bore of flange (8). Install seal (9) inside flange (8). Position the flange and install bolts (7). Install O-ring seal (6) on the flange.
Illustration 2 g01123599
Improper lift rigging can allow unit to tumble causing injury and damage.
Attach a suitable lifting device to the engine lifting eyes.
The weight of the 3516E Engine is approximately 9100 kg (20000 lb). The weight of the engine oil pan is approximately 409 kg (900 lb).
Lift the engine. Place the engine onto the engine oil pan.
Illustration 3 g06088407
Connect hose (4) from the oil level regulator.
Illustration 4 g01123597
Install bolts (3). Remove Tooling (C) from engine oil pan (2) and install remaining bolts (3).
Illustration 5 g01123595
Install bolts (1) that hold the connector for the engine oil pump to engine oil pan (2).
Fill the engine oil pan to the correct level that is indicated on the engine oil level gauge. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".