LINES GP-STICK 8U0982 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The boost pressure sensor may be located on the secondary fuel filter base or in the cylinder head.
Illustration 1 g01480192
Typical example
Slide locking tab (2) into the unlocked position.
Disconnect harness assembly (3) from boost pressure sensor (1). Note: The boost pressure sensor has a three-wire plug.
Use a deep socket to remove boost pressure sensor (1). Note: If necessary, remove the bracket for the harness assembly from the bypass tube.
Remove O-ring seal (4) from boost pressure sensor (1). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-6396 O-Ring Assembly Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The boost pressure sensor may be located on the secondary fuel filter base or in the cylinder head.
Illustration 2 g01480192
Typical example
Install a new O-ring seal (4) to the groove in boost pressure sensor (1). Lubricate the new O-ring seal with Tooling (A).
Use a deep socket to install boost pressure sensor (1). Tighten the boost pressure sensor to a torque of 10 N m (89 lb in). Note: If necessary, install the bracket for the harness assembly to the bypass tube.
Connect harness assembly (3) to boost pressure sensor (1).
Slide locking tab (2) into the locked position.