LINING-BRAKE 1967567 - Caterpillar

USB Flash Drive removable storage device errors
Note: USB Flash drive removable storage device errors can occur if the USB Flash drive device is removed from the display while the device is active. Do not remove the USB flash drive device until the screen message prompts you to remove the device.Damage to the USB flash drive removable storage device may require the USB Flash drive device to be formatted, or replaced.Root Folder
Root folder has Machine data folder which has the machine specific folder and an "All" folder. The following files may be found in the machine specific folder, and some may be placed in the "All" folder as a result of a data transfer to the display from a USB Flash drive device with data to be available to upload to all compatible displays.The root folder on the USB Flash drive removable storage device will contain some or all of the following file types:
A Site Map
Site Avoidance Zone
Terrain Logging
Map Recording
Program log
Display Settings
Machine Settings
GNSS Receiver Configuration
Design foldersThe following files may be in the root folder to upgrade the firmware for the device.
The Cat Grade Control CB460 Display
GNSS Receiver
CRxxx RadioThe Option_Keys_[display serial #].txt file for software support option may be in the root folder. This file is loaded into the display to enable the license support agreement.Site Map ("Name.svl", "Site.dxf", or "Name.bg.dxf")
This file is placed on the USB flash drive device in the folder with the display name (ECM Serial Number), located in the Machine Control Data folder. If this file is present, this file is always loaded. The site map provides a framework map of the whole site and contains the linework that is always visible. When a design is loaded, the design is placed with the site. The choice can also be made to guide horizontally to the lines that are displayed in this file.The site map can be in two different formats. The file can be in SV Linework format (".svl") or in a valid DXF format. The SV Linework format is a proprietary format that is produced by the Trimble Business Center Software.Name the file with one of the following names, depending on the format used.
"*.svl"
"Site.dxf"
"*.bg.dxf"The site map is loaded when the system is powered up. There should be only one file for the site map in the Site Design folder. The software will search and load the first "*.svl" file that is found. If an "*.svl" is not present, the software searches the root folder for a "Site.dxf" file. The software will load the first file that is found. If the software does not find a "Site.dxf" file, then the software will search the root folder for a background DXF ("*.bg.dxf") file. The software will load the first file that is found.Note: When possible, use the SV Linework ("*.svl") format. These files will load in seconds, rather than minutes.Site Avoidance Zone
Site Avoidance Zone files provide information about general areas on the site that must be avoided. One or more "*.avoid.dxf" or "*. avoid.svl" files may be