LINING 3B6966 - Caterpillar

Disassembly Procedure
Start By:
Remove the water cannon.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Mark parts as needed to aid in assembly. Plug all lines, hoses, and tubes. This action helps to prevent fluid loss and helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before the disassembly procedure is started, clean the exterior of the components to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g03391526
Note: Use a suitable lifting device to move water cannon (1). The water cannon weighs approximately 26.7 kg (58.9 lb).
Remove four bolts (2) from the non-rotating side of gear box housing (1) .Note: The disassemble and assemble procedure for the UP/DOWN gear box housing and the RIGHT/LEFT gear box housing are identical.Note: The rotating base tube is connected to the UP/DOWN gear box housing. The rotating nozzle tube is connected to the RIGHT/LEFT gear box housing. The two gear box housings are connected with a non-rotating tube (3) .
Illustration 2 g03391527
Remove O-ring (4) and O-ring (5) from the flange of non-rotating tube (3) .
Illustration 3 g03391528
Remove four bolts (6) .
Remove motor (7) from gear box housing (1) .
Illustration 4 g03391529
Remove O-ring (8). Remove five bolts (9) .
Remove the adapter from motor (7) .
Illustration 5 g03391552
Remove motor seal (10) .
Illustration 6 g03391553
Remove four bolts (12). Remove worm drive gear (13) from gear box housing (1) .Note: Remove worm drive gear (13) by rotating the worm drive gear out of the ring gear. Hold the mounting plate securely while the worm gear shaft is being rotated.
Illustration 7 g03391559
Remove four bolts (14) from the rotating tube side of gear box housing (1) .
Illustration 8 g03391560
Illustration 9 g03391571
Note: Steel stops have a double hex head. Plastic plugs have a single hex head. Plastic plugs may be left in place.
Remove one stop bolt (15) on each side of gear box housing (1) .
Remove the ring gear assembly from gear box housing (1) .
Illustration 10 g03391561
Remove three bolts (16). Remove ring gear (17).
Remove Teflon seal (18) from each end of ring gear (17) .
Illustration 11 g03391572
Remove O-rings (19) .