LINING 5F1094 - Caterpillar

SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 1*******
0-2000 hrs 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 4.0-hour job for Group 1
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 2*******
0-2000 hrs 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 4.0-hour job for Group 2
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Before installing the harness on the machine, locate the black tape (TAPE-BK) and add a "MARK" on the air restricted switch and ether solenoid branch 92 cm from the last connector. Refer to Image 1.1.1.
Image1.1.1
Begin the harness mounting by the black tape. Locate it on the ladder clip at the rear of the engine. Refer to Image 1.2.1. Route the harness on both sides of the engine. Be careful to avoid interferences.
Image1.2.1
Follow the mounting procedure below for the ether solenoid and air restricted switch branch. Refer to Image 1.3.1.
Image1.3.1
Locate "MARK" on the harness just after the P-clip. Refer to Image 1.4.1.
Put the air restricted switch branch between both bolts. Refer to Image 1.4.2.
Begin to attach the harness by the top, keeping the air restricted switch branch between both bolts. Refer to Image 1.4.2.
Image1.4.1
Image1.4.2
Image1.4.3
Assemble the harness on the P-clip.
Orient the ladder clip same as Image 1.5.1.
Be careful to not pull the connector wires and to keep enough gap between the top of the engine and solenoid leads. Refer to Image 1.5.2.
Image1.5.1
Image1.5.2