LINK ASSY. 1027673 - Caterpillar

Illustration 1 g00584638
Illustration 2 g00584633
Improper lifting and improper tie-downs can allow the load to shift and cause injury or damage.
The weight and the instructions that are given herein describe the machine as the machine is manufactured by Caterpillar.Refer to the Operation and Maintenance, "Specifications" for specific weight information.
Use proper rated cables and slings for lifting. The crane should be positioned so that the machine is lifted parallel to the ground.
To prevent contact with the machine, lifting cables should have sufficient length.
Use the rear eyes and the front eyes that are provided on the lower frame to fasten tie-downs. Use corner protectors for sharp corners.
Move the hydraulic lockout control (lever) to the LOCKED position.Lifting the Machine Segments
Machine Without Implements
Illustration 3 g00836830
Remove center engine hood (1) .
Illustration 4 g00584638
Fasten a proper rated wire cable to each lifting eye with a shackle. This machine has four lifting points on the front of the machine. The machine also has one lifting point on the rear of the machine.By using an appropriate lifting device, put tension on the lifting cables and slowly lift the machine.Counterweight
Illustration 5 g00583951
Refer to Operation and Maintenance Manual, "Counterweight Removal and Installation" for specific information.Cab
Illustration 6 g00581737
Install two M16 X P2 lifting eyebolts into the corners of the cab. The lifting eyebolts should be 180 degrees away from each other on the top of the cab. Attach properly rated wire cables to the lifting eyebolts.Stick with Bucket Cylinder
Illustration 7 g00581738
Use the two lifting eyes that are provided in the brackets on the top of the stick. Install shackles through the lifting eyes and fasten properly rated wire cable to the front section of the stick. Use a cloth in order to protect the lifting cable from being damaged by the edges of the stick.Slowly lift the stick with the bucket cylinder.Bucket
Illustration 8 g00115251
(1) Pin (2) Sleeve (3) Bolts (4) NutsInstall pin (1) and sleeve (2) in the brackets of the bucket. Illustration 8 indicates the method to secure pin (1) with bolts (3) and nuts (4). Fasten two proper rated wire cables to pin (1) .Boom with Stick Cylinder
Illustration 9 g00581739
Use the two lifting eyes that are on top of the boom. Fasten two properly rated wire cables to the lifting eyes with shackles and secure the piston rod to the cylinder tube.Slowly lift the boom and the stick cylinder.Boom Cylinder
Illustration 10 g00581741
Fasten two properly rated wire cables to the boom cylinder and secure the piston rod to the cylinder tube.Slowly lift the boom cylinder.Walkway
Illustration 11 g00581742
Use two properly rated wire cables. Fasten the lifting cables to the positions that are indicated in Illustration 11.Lift the walkways one at a time.