LINK AS-TRACK 1028077 - Caterpillar

Illustration 5 g00102805
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.
Remove the oil drain valve plug.
Illustration 6 g00293719
Install a Swivel Hose with clear plastic tubing in order to open the drain valve. Drain the oil into a suitable container.
Remove the Swivel Hose in order to close the drain valve.
Inspect the O-ring. Replace the O-ring if wear or damage is evident.
Clean the drain plug. Install the drain plug.
Illustration 7 g00611344
Open the access door that is located on the right side of the machine.
Clean the pump. Clean the hydraulic lines. Clean the hydraulic tank.
Illustration 8 g00102926
Remove the plug from the tube. Allow the oil to drain into a container.
Inspect the O-ring. Replace the O-ring if wear or damage is evident.
Clean the plug. Install the plug and the O-ring into the drain port.
Illustration 9 g00101490
(4) Bolt. (5) Washer. (6) Cover. (7) Spring. (8) Screen.
Remove bolts (4), washers (5), and cover (6) .Note: Used filters and used fluids should always be disposed of according to established local regulations.Note: Do not allow spring (7) to fall into the tank.
Remove spring (7) and screen (8) .Note: Refer to Operation and Maintenance, "General Hazard Information" for information on containing fluid spillage.
Wash the screen in a clean nonflammable solvent. Allow the screen to dry. Inspect the screen. Replace the screen, if the screen is damaged.
Illustration 10 g00101492
(9) O-ring seal. (10) O-ring seal.
Inspect O-ring seals (9) and (10). Replace the O-ring seals if wear or damage is evident.
Install a new screen and spring (7). Then install cover (6), washers (5), and bolts (4) .Note: Make sure that the O-ring seals and the spring are properly positioned during installation.
Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, "Capacities (Refill)".
Inspect the O-ring seal on the filler plug for damage. Replace the O-ring, if necessary. Clean the filler plug. Install the filler plug.
Illustration 11 g00101460
Remove the pressure cap.
Illustration 12 g00102811
Inspect the pressure cap. Clean the pressure cap. Replace the pressure cap if damage is evident.
Install the pressure cap.
Illustration 13 g00102927
Note: Make no attempt to start the engine until the pump has been filled with hydraulic oil. Serious damage to the hydraulic components can result.
When the hydraulic oil has been replaced,the air must be removed from the hydraulic oil system. Use the following procedure to remove the air from the hydraulic oil system.
While the engine is stopped, remove the vent plug on the top of the pump. Leave the vent plug unattached for several minutes until the pump is filled with hydraulic oil. After the pump is filled with hydraulic oil, tighten the vent plug. Start the engine. When the engine is at low idle, fully raise the boom. Hold the boom in this position.
Stop the engine. Slowly lower the boom until the implement is on the ground. This pressurizes the hydraulic tank.
Slowly loosen the vent plug for several turns until the hydraulic oil flows out of the opening for the vent plug. This indicates that the air has been released from the pump. Tighten the vent plug