LINK-TRACK 1362404 - Caterpillar

Introduction
Illustration 1 g06212547The overload warning device is a system that warns the operator that the pump pressure for the boom cylinder lines has exceeded a set value. The alarm setting for the overload warning device on your machine should be checked for the proper adjustment. Use the information that follows to input the correct value and reset the parameter for the overload warning device.Note: The engine speed and/or the machine configuration that is used during this test can affect the results of this test. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for the engine speed that was used for this test.Note: The relief valve pressure settings must be set to the relief valve pressure specification before performing this operational check. Refer to Testing and Adjusting, "Specifications".Input The Value Of The Threshold Pressure For The Overload Warning Device
Illustration 2 g06241576
Select "Setting" from the main menu in the monitor.
Select "Service" in the "Setting" menu.
Input the password "9992" and select "ENTER".
Select "Configurations" from the "Service" menu.
Select "Machine Attachments" from the "Configurations" menu.
Illustration 3 g06212555
Select "Overload Press Sensor" from the "Machine Attachments" menu. Set the "Overload Press Sensor" to "Installed".
Illustration 4 g06203538
Select "Overload Press Threshold" from the "Machine Attachments" menu. Set the overload pressure threshold to 17000 kPa (2465 psi).
Press "OK" to set the value into memory.