LINK-TRACK MASTER 1V4605 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
B     5P-1733     Seal Locator As     1    
5P-3594 (1) Locator     1    
C     5P-1737     Bolts     3    
1T-0720 (1) Bolts     3    
D     6V-6143     Seal Installer     1    
8T-2855 (1) Sleeve Installer     1    
E     9S-8858     Nut (Seal Installer)     1    
( 1 ) Use with a BrakeSaver
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The rear seal and the wear sleeve must be replaced at the same time. Once the seal and the wear sleeve are separated, these components cannot be used again. Refer to Special Instruction, SMHS8508, "Special Handling Information and Installation Instructions for Crankshaft Seal Groups that Have Hydrodynamic Grooves In the Sealing Lip"before the seal is serviced.
Illustration 1 g01076371
Note: Do not use any type of lubricant during the installation of the crankshaft rear seal and wear sleeve.
Before installation of the crankshaft rear seal and the wear sleeve, inspect the crankshaft for scratches. Also, inspect the crankshaft for any distortion on the surface that may lead to an out of round condition. Use a polishing cloth in order to remove any imperfections on the crankshaft.
Clean the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (2) .
Fasten Tooling (B) to crankshaft (3) with Tooling (C) .
The front and rear seals and wear sleeves have different spiral grooves in the seal. Because of this type of design, the front seal group for an engine is different from the rear seal group. If a seal group is installed on the wrong end of the engine, oil can actually be taken out of the engine instead of moving oil back into the engine.
Note: Install the seal with the arrow that shows the direction of crankshaft rotation toward the rear of the engine.
Position wear sleeve (2) and crankshaft rear seal (1) on Tooling (B) . Install Tooling (D) on Tooling (B) . Lubricate the face of the washer on Tooling (E) . Install Tooling (E) on Tooling (B) .
Tighten Tooling (E) until Tooling (D) contacts Tooling (B) .
Remove Tooling (B) , Tooling (C) , Tooling (D) , and Tooling (E) . Check the crankshaft rear seal and the wear sleeve for the correct installation.End By: Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".