LINK AS-TRACK 2279960 - Caterpillar

Illustration 15 g03744371
Follow on screen instruction (20) .
When calibrations are complete, move propulsion lever (1) to the NEUTRAL position.
Select "Next" button (18) .
Illustration 16 g03744398
When the forward pump solenoid calibration is complete, a "Calibration Successful" window will open. Select "Continue" button (21) .
Illustration 17 g03744401
Follow on screen instruction (22) .
Move propulsion lever (1) slowly to the full REVERSE position.
Wait for the calibration to compete.
Illustration 18 g03744407
Follow on screen instruction (23) .
When calibrations are complete, move propulsion lever (1) to the NEUTRAL position.
Select "Next" button (18) .
Illustration 19 g03744408
When the reverse pump solenoid calibration is complete, a "Calibration Successful" window will open. Select "Finish" button (24) .
Illustration 20 g03744414
Select "Transmission Drive Pump Pressure Override Calibration" (25) .
Select "Start" button (12) .
Illustration 21 g03744418
Read the on screen warnings. Select "OK" button (13) .
Illustration 22 g03744627
Follow set up instructions (26) .
Park brake valve (9) must be closed manually to prevent machine movement during the calibration.
Propel lever (1) must be in the NEUTRAL position.
Engine must be running and set to high idle.
Parking brake switch (2) must be in the OFF position.
Hydraulic oil temperature must be between 30 °C (86 °F) and 70 °C (158 °F).
Verify that all conditions are met then select"Next" button (18) .
Illustration 23 g03744639
Follow on screen instructions (27) .
Move propulsion lever (1) slowly to the full FORWARD position.
Wait for the calibration to complete.
Illustration 24 g03744657
Follow on screen instructions (28) .
Move propulsion lever (1) slowly to the full REVERSE position.
Wait for the calibration to complete.
Illustration 25 g03744706
Follow on screen instructions (29) .
When calibrations are complete, move propulsion lever (1) to the NEUTRAL position.
Select "Next" button (18) .
Illustration 26 g03744716
When the Transmission drive pump pressure override calibration is complete, a "Calibration Successful" window will open. Select "Finish" button (30) .
Remove the tooling.
Press throttle control switch (4) in order to place the engine in low idle.Note: Two things indicate when the engine is at low idle. First, the engine rpm will appear on machine display (5). Second, the indicator light next to the throttle switch will go out.
Move engine start switch (6) to the OFF position.
Lift deck plate (7) .
Loosen lock ring (8). Rotate needle valve (9) fully counterclockwise in order to open the brake valve.
Close deck plate (7) .